LEV testing

Local exhaust ventilation (LEV) checks help control the release of hazardous airborne substances from a process into the workplace environment.

The aim of LEV checking is to control the emission as close as possible to the point of release, and prevent it from entering the air of the workplace.

Envirochem routinely undertake LEV checks for many clients on equipment including:

  • Fume cabinets
  • Spray booths
  • Dust extract systems

These should be tested 14 monthly or after any modifications, as specified within the Health and Safety Executive’s HSE Guidance Notes HS(G)54 and HS(G)37.

We produce thorough reports detailing duct velocities static pressures and flow rates and make comments on any observed changes in the system reading or their possible causes.

 

For more on this and all our services please fill out the form below or call 01329 287 777

Contact Envirochem now
Sending

Oil mist particles in the air

Many manufacturing activities require oil based lubricants to be used as part of their process. We can test for oil mist particles in the air whilst the employee is carrying out their normal everyday works or as background checks within a workshop or area.

Within this test, we can also check the total amount of particulates the employee is being exposed to as well as any concentration of oil.

For more on this and for all our services please fill out the form below or call on 01329 287 777

Contact Envirochem now
Sending

Testing for Anions which can cause – Metal degradation and rusting

An ongoing sampling project for our occupational hygiene team is to analysis six separate manufactured parts for anions, which can cause metal degradation and rusting. Within this industry, the parts are being used for submarine engines; aircraft parts etc therefore any chemical impurities can cause problems with the system, resulting in additional extra cost.

A swab sample is taken on the surface of the metal and analysed for fluoride, sulphate and chloride. This is then analysed with a blank swab, run through the IC and converted to the desired units of the client.

For more information on this and all our services please fill out the form below or call on 01329 287 777

Contact Envirochem now
Sending

New Shame for Southampton for breaching safe levels for fine particles in the air, known as PM2.5.

The City of Southampton is among that of 40 locations around the UK that have been found to be breaching safety levels set by the World Heath Organisation (WHO). Southampton has recently been found again to have high levels of air pollution.

Public Health England have released figures for the percentage of adult deaths in the city attributed to the air pollution was 6.3% in 2011, the highest percentage for the South East.

However, Southampton is set to be only 1 of 5 cities in the UK to begin new low emissions zones in 2020, this will see some diesel vehicles charged to drive in the city centre.

The WHO have warned that poor air quality is a major cause of disease and death. One of the ways that the WHO assesses air quality is by looking at the levels of pollution know as particulate matter (PMs). It has been found that 11 urban areas across the UK have exceed the safe limit set for PM10 and 40 towns and cities have breached the limits set for PM2.5.

The risk of conditions such as Stroke, Heart Disease and asthma increases as air quality declines, in these areas that breached the safe limits,

For more on this story please follow the link to the Daily Echo 

For information or advice from us please follow the link below;

Contact Envirochem now
Sending

 


ASBESTOS FIBRE IDENTIFICATION

ASBESTOS FIBRE IDENTIFICATION

Asbestos Fibre Identification in accordance with our UKAS accreditation and HSG 248.

Envirochem offers a competitive Asbestos Fibre Identification service returning results by email within 24 hours in most cases.

In the United Kingdom, the three most common forms of asbestos are chrysotile (white), amosite (brown) and crocidolite (blue). They are found in common building materials such as insulation board panels, spray coating, bonded cements, gaskets, insulation, textured coatings and vinyl flooring.

Samples can be delivered to our laboratory, or collected by our analysts.

An Asbestos Fibre Identification certificate is produced for each batch of samples analysed, which is available most commonly in PDF format via email.

Please fill out the form below for more information or call on 01329 287 777

 

Contact Envirochem now
Sending

Envirochem are UKAS accredited for sampling & analysis of total inhalable & respirable dusts.

DUST MONITORING

Envirochem are UKAS accredited for sampling & analysis of total inhalable & respirable dusts.

We are happy to undertake site visits, sampling and analysis, to meet the needs of our clients. The initial phase of any project is a discussion about the requirements and what is hoped to be achieve from the monitoring.

The aims of the project will affect the number and type of samples (static or personal, inhalable or respirable) required as well as the duration of sampling and the sample media.

  • As part of on-going COSHH assessments
  • To address a specific concern raised by an employee
  • Before and after modifications to site or equipment
  • During grit blasting of lead and other heavy metals

At our laboratory, following gravimetric analysis, we can also undertake further tests on the filters to assess type and concentration of airborne contaminates such as:

  • Lead and other heavy metals
  • Oil or ink mist
  • Fibre type and concentration
  • Silica type and concentration

Please see our accreditation’s schedule for our scope of accreditation within our quality section


GUIDANCE ON LEGIONNAIRES’ DISEASE FOR LANDLORDS

What is Legionnaires’ Disease?

Legionnaires’ Disease is a pneumonia like illness caused by the Legionella bacteria and can be fatal. The infection is caused by breathing in small droplets of water contaminated by the bacteria. The disease cannot be passed from one person to another.

Legionella bacteria are found in the natural environment and may contaminate and grow in water systems, including domestic hot and cold water systems. They survive low temperatures and thrive at temperatures between 20 – 45°C if the conditions are right. They are killed by high temperatures at 60°C or above.

Risk assessments

Landlords are under a duty to ensure that the risk of exposure to tenants, residents and visitors by Legionella is properly assessed and controlled.

Normally there is no reason why the landlord should not carry out this risk assessment himself/herself so long as they are competent. Usually there will be no need to employ a consultant. The assessment should be a straight forward simple exercise in ordinary domestic premises.

For most residential settings the risk assessment may well show the risks are low so long as simple control measures referred to in the next section are followed. This will apply to houses or flats with small domestic type water systems where the water turnover is high. Provided the risk assessment shows that the risks are insignificant and the control measures are being properly managed no further action would be necessary. It is important, however, to keep the assessment under review periodically in case anything changes to the system.

Control measures

Simple control measures will help manage the risk from Legionella and these should be maintained including:

  • flushing out the water system by running all outlets for at least 2 minutes where the premises have not been used e.g. before letting the property or if the property has stood empty for a time
  • avoiding debris getting into the system (e.g. making sure cold water tanks, if installed, have a tight fitting lid)
  • setting controls so that the hot water is heated to and stored at 60°C
  • the removal of any redundant pipe work
  • advising tenants to regularly clean, descale and disinfect shower heads

Advice for tenants

Landlords are entitled to expect the tenants will play their part in ensuring control measures are maintained. Landlords should:

  • inform tenants of potential risk of exposure to Legionella and its consequences
  • tell tenants of any action which arises from the landlords risk assessment if appropriate
  • tell tenants to inform the landlord if the hot water system is not heating properly or if there are any other problems with the system
  • tell the landlord if the cold water system is not running cold
  • tell tenants to keep the water turned over

 

Unoccupied premises

The risk from Legionella may increase if the property is unoccupied even for a short period. It is important that water is not left to stand in the hot or cold water systems. As a general rule, all outlets on hot and cold water systems should be used at least once a week for at least 2 minutes to maintain a degree of water flow and minimise the chances of stagnation. For long periods consider draining the system. Make sure that the system is flushed through when it is re-occupied by running all outlets for at least 2 minutes.

HSE Guidance

HSE have published detailed guidance and the relevant extract relating to residential accommodation is available here.

What is the letting agent’s responsibility?

As already indicated, landlords are responsible for making sure that the risks involving Legionella are properly assessed and controlled. Where a managing agent is used the management contract should specify who has responsibility. Landlords must assume that unless the managing agent takes on this responsibility, they as landlord will be responsible for compliance.

Do landlords need to employ a consultant or undertake sampling tests?

For straight forward residential accommodation the answer to this should be “no” as long as landlords are reasonably knowledgeable and competent. Sometimes agents and consultants tell landlords that they need to employ a consultant to conduct an annual check or even to have sampling undertaken. HSE guidance indicates that normally this will not be necessary. However, if a block of flats are involved, unless each flat has its own self-contained hot and cold water system, a more comprehensive risk assessment may be needed.

What happens if the landlord does not carry out his/her obligations?

The consequences can be serious. Landlords are legally required to manage properties so as not to expose tenants, residents and visitors to risk. Heavy fines or even imprisonment can be imposed especially if someone were to unfortunately die. Landlords can be prosecuted even if there is an exposure to risk without anyone actually becoming ill.

Original Source:http://www.rla.org.uk/landlord/guides/legionnaires_disease.shtml?zoom_highlight=legionella

For more information on this and for all our services please call on 01329 287 777 or fill out the form below;

Contact Envirochem now
Sending

EMISSIONS TESTING

EMISSIONS TESTING

Envirochem offer emissions testing for stack monitoring to technical guidance notes M1 and M2 including:

  • Crematoria emmisions to process guidance note PG 5/2 (95)
  • Local Exhaust Ventilation (LEV) checks
  • Particulate Emissions – Isokinetic based on TGN M1 & M2
  • Solvent Emissions Testing

For more information please fill out the form below or call on 01329 287 777

Contact Envirochem now
Sending

The Built Environment

THE BUILT ENVIRONMENT

We offer Chemical Analysis for the Built Environment where sensitivity is required in understanding the composition and nature of various substances:

  • UKAS accredited Lead in paint analysis
  • UKAS accredited Lead and Chromuim in paint testing
  • Anthrax or gypsum in plaster
  • Chlorofluorocarbons (CFCs) in foam and polystyrene
  • Mould analysis
  • Paint layers and thickness
  • Tests for over 30 metals in paint

For more information on this and all our services please fill out the form below or call 01329 287 777

Contact Envirochem now
Sending

BRITISH OCCUPATIONAL HYGIENE SOCIETY COURSES

Envirochem are an approved British Occupational Hygiene Society (BOHS) training provider for a range of asbestos related courses. The following courses are available periodically at our offices, please contact us for more information.

 

  • P401 – Identification of Asbestos in Bulk Samples (PLM)

    Theoretical and practical knowledge in the techniques of asbestos sample identification using stereo and polarised light microscopy.

  • P402 – Building Surveys and Bulk Analysis for Asbestos

    Theoretical and practical knowledge in the techniques of building surveying and sampling of asbestos containing materials.

  • P403 – Asbestos Fibre Counting (PCM) – (including Sampling Strategies)

    Theoretical and practical knowledge in the techniques of fibre counting of asbestos air samples using phase contrast microscopy.

  • P404 – Air Sampling and Clearance Testing of Asbestos

    Theoretical and practical knowledge in the techniques of air sampling and clearance testing of asbestos during removal work.

  • P405 – Management of Asbestos in Buildings

    Practical knowledge and skills to manage asbestos in buildings and audit asbestos removal projects.

For more information please call us on 01329 287 777 or fill out the form below

Contact Envirochem now
Sending